Manhole Rehab Products - DINJER Stop Leak Rapid Set

PRODUCT DESCRIPTION
DINJER Stop Leak is a premium rapid setting repair material specially designed to stop leaks in concrete walls, precast concrete, floors, cisterns, bulkheads, etc. with a 30-60 second set rate after mixed.

APPLICATION
Surface Preparation
Enlarge crack or hole to width and depth of at least one (1) inch. Use an undercut or square cut (not “V” shaped cut). Clean patch area out and dampen with clean water.

TECHNICAL ANALYSIS
Set Time: 1–4 minutes
Compressive Strength, ASTM C 109
1 Hr 1800 psi
1 Day 3275 psi
7 Days 4010 psi
28 Days 4625 psi

MIXING
Add a small amount of clean water until material gains the consistency of putty. Do not mix more material than can be placed in 2 minutes.

PLACEMENT
When material becomes warm, press material into patch area and hold until patch becomes hard. Scrape off excess material.

FOR BEST RESULTS
Keep patched area damp for at least 30 minutes. To stop flowing water, seal crack from top to bottom or the point of maximum water pressure. To make the closure, delay placing DINJER Stop Leak until warm, forcing it into opening and exerting pressure for a few minutes until the material becomes hard.

HOT WEATHER
(Above 80 degrees F) Protect material from sun and wind. Use cold water to delay setting.

COLD WEATHER
(Below 55 degrees F) Cold temperatures delay setting and make it difficult to stop flowing water. Warm unmixed material and mix with warm water. Keep the area damp for at least 30 minutes.

CLEAN UP
Clean up is simple with soap and water. Rinse tools before material hardens.

PACKAGING
Available in 50 lb. pails.

COVERAGE
One (1) lb. fills approximately 17 cu.in. and will fill a crack ¾” x ¾” 30” long.

IMPORTANT: STORE IN A DRY PLACE

CAUTION
Use of this product may be hazardous to your health. This product contains Portland cement and Silica sand. Prolonged inhalation may cause delayed lung injury including silicosis and possibly cancer. Avoid direct contact with skin and eyes. In case of contact, flush with plenty of water for at least 15 minutes. Contact a physician. Wash exposed skin areas promptly with water. Do not take internally. Keep out of reach of children. Please consult MSDS prior to use.